Hempel Light Primer 2 Part Epoxy - All Sizes & Colours
The Hempel Light Primer 45551 is a two part epoxy high build solvent based primer and undercoat that helps to prevent corrosion.
Hempel Light Primer 2 Part Epoxy - All Sizes & Colours 45551
Blakes Hempel's Light Primer is a two pack, high build, solvent based primer and undercoat for the protection of all substrates above and below the waterline. Particularly suitable for aluminium and as a primer for keels and rudders.
Specifications
- Application method: Brush, roller, pad & spray
- Thinner and Tool Cleaner: Thinners No.5 (brush/ roller/ pad) up to 10%, (spray) up to 40%
- Semi-gloss
- Suitable for glass fibre, steel, aluminium and plywood
- For interior and exterior use, above and below the waterline
- Coverage: 8.5m²/ 1L
- Minimum application temperature: 10℃
- Touch dry after 3 hours (20℃ / 68℉)
- Hard dry after 6 hours (20℃ / 68℉)
- Fully cured after 7 days (20℃ / 68℉)
- Ready to sand after 48 hours (20℃ / 68℉)
Frequently Asked Questions
- Touch dry after 6 hours (10℃ / 50℉)
- Touch dry after 3 hours (20℃ / 68℉)
- Hard dry after 12 hours (10℃ / 50℉)
- Hard dry after 6 hours (20℃ / 68℉)
- Surface dry after 14 days (10℃ / 50℉)
- Surface dry after 7 days (20℃ / 68℉)
- Ready to sand after 48 hours (20℃ / 68℉)
- Ensure all surfaces are clean, oil free and dry
- Clean with Degreaser or Surface Cleaner
- Stir all products well before use
- If overcoating times are exceeded, abrade the surface and wash off with fresh water
On a previously coated surface
- Abrade to remove loose matter and provide a suitable key
- Wash surface with fresh water and allow to dry
- Apply Epoxy Primer Undercoat as required, followed by the relevant topcoat / antifoul.
On a previously uncoated surface
- Prime porous surfaces with one coat of Epoxy Primer Undercoat thinned 20% with Thinners No.5
- Then apply 5 coats of Epoxy Primer Undercoat before applying the required topcoat / antifoul or tie coat
- Thinners can be added to assist application under certain conditions
You can use the Hempel Light Primer on all glass fibre, steel, aluminium and plywood boats. This light primer is for interior and exterior use, both above and below the waterline.
For uncoated surfaces below the waterlne, it is recommended to apply 3 to 5 coats. For uncoated surfaces above the waterline, it is recommended to apply 2 coats. Surfaces that have been coated previously only need 1 undiluted coat.
SKU | Configurable_MAPV1070 |
---|---|
MPN | 45551 |
EAN / GTIN | 5709516002809 |
Brand | Hempel |
Range | Light |
Datasheet | Hempel Light Primer Datasheet |
Loyalty Discount | Yes |
Area Of Use | Interior & Exterior |
Time To Dry | 3 hours at 20°C |